Recent content by FFRSpec72

I had fuel delivery issues and found the problem but also found other problems in the fuel line routing, so I need to replace the high pressure line (running EFI) and return lines (from fuel cell to EFI fuel rails). I have hard line now (3/16 high pressure side and 1/4 return), and been looking...

http://www.pacificraceways.com/UserFiles/Forms/RoadCourseTest%20TuneInfoSheet.pdf

405 between Northeast Eighth Street in Bellevue and SR 520, from 11 p.m., Friday, Sept. 23, until 4 a.m., Monday, Sept. 26 is closed due to bridge demolition.

I need to have a radiator checked out for posible blockage (brass 3 core), any recommendation on the east side of Seatle? Chasing an over heating issue.

Any place in Seattle to get high pressure SS braided fuel lines made with AN fittings?

Is there a set frequency range that ICSCC/IRDC uses for in car radios? UHF or VHF?

I looked through the 2010 rules and did not see any requirement on padding the exposed roll cage bars that may come in contact with the driver, did I miss something? If used I did not see any requirement for this to be SFI or high density. I found the following in NASA: 15.6.4 Padding All roll...

If you need to get a once a month fix; PUT DOWN FAST LAPS IN YOUR CAR AT PGP WITH LAP ATTACK FALL-WINTER SERIES STARTING OCT. 10 You may not realize it, but there's a race car in your garage. It may not have a number on the door or racing stripes, but your car -- whatever the make, model or...

I was amazed at this interior and all the safety gear

I have to get my 55cf tank filed with Argon/CO2 what is the best place in the Seattle/Woodinville/Redmond area to get this filled (I own my own tank)?

What is meant by the sentence "All convertibles must have certified roll cage no exceptions!", does this mean that the cage has to meet the same as the ICSCC race rules requirements? Reason I’m asking is that there are some Factory Five roadster folks that would like to try the driver’s training...

Anyone know of a good (cheap) place to stash a trailer in the Redmond, Kirklaknd, Wooinville, Bellevue area ?

Anyone know or have a pointer to information on what is need to licence a out of state car trailer in Washington? Do you have to pay tax? Need an inspection of some sort?

I see that Tem Continental has their membership application/renewal up on www.motorsportreg.com is that something that IRDC could do, makes for 1 stop shopping, or did I miss it already being up there?

I'm looking @ a Ford Ranger v6 (3.0) as a tow vehicle, the car being towed is 2200# and trailer is between 1200-1800# and towing capacity is of the Ranger is 6000#. Has anyone had any experience with this combination (so it would be like towing a SM)?